Arduino Uno R3 error
I have an arduino uno R3. I am able to upload the programs with no connectivity issues. But there is a problem while executing the program and I don't know what that is. The 13th pin led is not blinking as the default bootloader program comes with preloaded blink program. I am not able to reset the board too. What might be causing the problem? I even tried to reload the bootloader program. But the same think happens yet again. Thanks in advance and Regards, Rishi.
Have you tried to blink one led with pin 2 or 3 ( any of the digital pins ). You might have a working Arduino uno but your led on the board can be broken. Otherwise,you should try to flash the bootloader with a secondary arduino and check if you get the same issue.
I cannot find UID of my Arduino
Arduino Program Reset Bug
arduino uno R3 input pins with gsm shield
Light weight machine to machine communication with Arduino
Interfacing RM5 evolution coin acceptor with arduino
Arduino-ESP8266 Sending URL from a client browser connected to the esp8266 AP and receiving the entered URL in the arduino board
Need explanations about a code relative to MPU6050
Arduino Programmer only works after unlugging and plugging back in
How do I communicate between Arduino board and Intel Edison Arduino board using XBee S2?
I cannot solve my arduino program error
2.4 inch TFT LCD SPFD5408 with Arduino Uno - touch not working
DAC0808 doesn't want tranfer to analog
Trouble in programming arduino with esp8266
How to control a servo motor with Windows Remote Arduino?
Set baud rate to esp8266 at 9600
Arduino AC Dimmer - serial communication lost due to interrupt